Fabric Forms

The use of fabric to form concrete is a revolutionary innovation in concrete forming. Fabric forming is as powerful a change in this century as the gypsum wall board was in the last. Fabric forming represents a true paradigm shift to the concrete forming industry.

Alandson's carries products manufactured by Fab-Form Industries. Not only do Fab-Form's innovative products make new construction easier and less costly, they prevent rising dampness and protect against ground moisture in new construction.

COLUMN FORMS

Fast-Tube^™ is a revolutionary column form replacing cardboard tubes. Manufactured from high strength fabric, Fast-Tube^™ comes in 120' rolls and in diameters ranging from 6" to 12". Installation, pouring and stripping is quick and simple.

DRIER. FROM THE GROUND UP.

Fastfoot^® is a fabric footing form that prevents rising damp. Stakes are driven into the ground, 2x4 screed boards attached at the correct height, and Fastfoot^® is stapled to each 2x4 to form and protect the concrete from ground moisture. Fastfoot^® can be used as a complete footing form, forming the sides and base of the footing as shown below:

Fastfoot^® can be used as an edge form , forming the sides only. Fastfoot^® edging is used where the footing (or slab) is too wide to be formed with a single width of fabric:

FORM COLUMN PADS WITH FABRIC

Fastbags^® are a revolutionary footing form for column and point load footings. Manufactured from non-woven fabric, Fastbags^® are the perfect environmental solution to the cost-conscious contractor.